NEC SV8500 Operation And Maintenance Manual - page 571
– 524 –
CHAPTER 3
System Messages
36-T: Fusion Health Check Report (Permanent)
[36-T] Fusion Health Check Report message (Permanent) is output when the timeout of Fusion health check has
been detected ten consecutive times after an output of temporary timeout of Fusion Health Check of [36-F]
Fusion Health Check Report (Temporary/Permanent). At this time, the temporary timeout is not counted.
Fusion Health Check is executed by assigning the system data [ASYDL/ASYDN: SYS1, Index 530]. Also, the
system message [36-F/36-K/36-T] is output when the timeout of Fusion Health Check is detected, by assigning
the system data [ASYDL/ASYDN: SYS1, Index 534]. Refer to Office Data Specifications for the detail.
Note:
[36-T] Fusion Health Check Report (Permanent) can be output instead of [36-F] Fusion Health Check
Report (Temporary/Permanent) for the permanent timeout of Fusion Health Check when the system data
[ASYDL/ASYDN: SYS1, Index 655, Bit 0-2 = 1] is assigned, which can be specified on a Fusion type
basis as shown on the table below.
Note:
When [36-F] Fusion Health Check Report (Temporary/Permanent) or [36-T] Fusion Health Check Re-
port (Permanent) is output, if there is no alternate route, a call cannot be made to the node where a fail-
ure is occurring until [36-K] Fusion Health Check Report (Recovery) is output. However, a call can be
made within the same node or node where a failure is not occurring.
Note:
When [36-F] Fusion Health Check Report (Temporary/Permanent) or
[36-T]
Fusion Health Check Re-
port
(Permanent) is output, Fusion Health Check Report (Recovery) [36-K] is output when released.
The details of this message are in the following:
Default Alarm
Default Grade
Grade Modified
Lamp Modified
SUP
-
-
Fusion Type
Target Device
Remark
P2P
External LAN
o
External LAN
Except for Ether
Link Disconnection
Legacy
FCH/IPTRK
HUB
o
FCH/IPTRK
Except for Internal
LAN Cable Discon-
nection
Internal LAN
Direct Connection
HUB
o
HUB