NEC SV8500 Operation And Maintenance Manual - page 787
– 740 –
CHAPTER 7
Maintenance Commands
Readout or input data are different depends on Parameter Type. The data in each Parameter Type are shown
below.
•
Parameter Type=STN is selected, read out or input the following data:
TN: Tenant
Number
STN:
Physical Station Number (0-9, #, * [Maximum 6 digits])
Phone book Data Num:
Number of Local Phone book Data (0-100) is displayed.
•
Parameter Type=TELN(LDM) is selected, read out or input the following data:
UGN:
User Group Number (1-255)
TELN(LDM): Telephone
Number
(0-9, #, * [Maximum 16 digits])
Phone book Data Num:
Number of Local Phone book Data (0-100) is displayed.
•
Parameter Type=TELN(NDM) is selected, read out or input the following data:
UGN:
User Group Number (1-255)
TELN(NDM): Telephone
Number
(0-9, #, * [Maximum 16 digits])
Phone book Data Num:
Number of Local Phone book Data (0-100) is displayed.
•
Parameter Type=LENS is selected, read out or input the following data:
LENS: Line
Equipment
Number
Phone book Data Num:
Number of Local Phone book Data (0-100) is displayed.
Buttons
Get:
Read out the data.
Execute: Start the process.
Exit:
Exit this command.