NEC SV8500 Operation And Maintenance Manual - page 604
of
975
– 557 –
CHAPTER 5
Operation Procedure for System with PIR
STEP 4
Pull out the card mounted on the slot.
STEP 5
Make sure the switch setting of the new IPPAD circuit card is the same as the one replaced.
STEP 6
Turn on (upward) MB key on the new IPPAD card.
STEP 7
Insert the new circuit card to the slot.
STEP 8
Insert the LAN cable to IP-LAN connector.
STEP 9
Turn off (downward) MB key on the IPPAD card.
•
OPE lamp lights green on the IPPAD circuit card.
[End]