NEC SV8500 Operation And Maintenance Manual - page 626
of
975
– 579 –
CHAPTER 5
Operation Procedure for System with PIR
STEP 6: Remove the cables from the FANU connector using a flat-blade screwdriver.
STEP 7: Loosen the screws fixing the FANC brackets on both sides.
STEP 8: Remove the FANC.
•
Slide the FANC bracket to the right a little. (about 1cm)
•
Pull the bracket toward you.
FANU connector
flat-blade screwdriver
screw (left)
a Phillips head screwdriver
screw (right
[1]
[1]
[2]
[1] Slightly slide the FANC to the right
[2] Pull the FANC toward you.
brackets