NEC SV8500 Operation And Maintenance Manual - page 758
– 711 –
CHAPTER 7
Maintenance Commands
ATRFN: Assignment of Traffic Measurement Order for FCCS Network
1. Functional Outline
This command is used to assign and delete traffic measurement programs available on the Ethernet. A request
for traffic measurement is performed on a network basis when a traffic measurement instruction has been
assigned by this command. The collected traffic measurement data can be stored on the HD of the PCPro
[connected to the Network Control Node (NCN)], that can be designated on the basis of the traffic measurement
type. This command can be used at the NCN only.
2. Parameters
Input Data
TYPE:
Type of Traffic Measurement (1-19) (See Table 7-1)
Port:Traffic Information Output Terminal Number (0-7: IOC, 8: LAN, 9:NMS)
Interval:Output interval (0, 30-120)
Assign the data (30-120) in ten minute increments. When assigning 0 (available when any of TYPE 3-18
is selected), instead specify your desired output time in the Output TIME parameters below.
Start TIME
,
End TIME
Output TIME:This data entry is valid only when Interval=0.
Start LGRT:Start External Route Number (available when TYPE 2/5/8 is selected)
End LGRT:End External Route Number (available when TYPE 2/5/8 is selected)
Start C_RT:Start Connection Route Number (available when TYPE 18/19 is selected)
End C_RT:End Connection Route Number (available when TYPE 18/19 is selected)
Note:
The selected traffic measurement data, except for TYPE 1 (Terminal Traffic), is collected with the whole
network system as a single unit.
Table 7-1 ATRFN - Type of Traffic Measurement Explanation
DATA
MEANING
DATA
MEANING
1
Terminal Traffic
2
Route Traffic
3
Station Peg Count Note 4
4
ATT Peg Count Note 4, Note 5
5
Route Peg Count
6
Service Peg Count Note 4
8
UCD Route Peg Count
9
UCD Group Peg Count
10
UCD Station Peg Count
15
ATT Answering Peg Count Note 3
,
18
Connection Route Peg Count
19
Connection Route Traffic