NEC SV8500 Operation And Maintenance Manual - page 581
of
975
– 534 –
CHAPTER 4
Fault Repair Procedures
[TRACERT]: Traces Route Towards Corresponding Point.
TRACERT command is used to confirm the routing setting of the router on the network route when result
of ping command had any kind of fault.
Note:
Some router is set not to pass the ICMP command depending on the network environment.
Method: tracert IP address (ie: tracert 192.168.2.10)
C:\TEMP>tracert 192.168.2.10
Tracing route to 192.168.2.10
over a maximum of 30 hops:
1 40ms 40ms 40ms lan1.xx.jp [192.xxx.xxx.xxx]
2 40ms 40ms 40ms lan2.xx.jp [192.xxx.xxx.xxx]
3 40ms 40ms 40ms lan3.xx.jp [192.xxx.xxx.xxx]
4 40ms 40ms 40ms lan4.xx.jp [192.xxx.xxx.xxx]
Trace complete.