NEC SV8500 Operation And Maintenance Manual - page 821
– 774 –
CHAPTER 7
Maintenance Commands
Select ALL TYPE or RANGE TYPE in the drop-down list to set the range of registered data to be read out
and listed in Data field.
•
ALL TYPE:
All the registered data is to be listed.
•
RANGE TYPE: Registered data is to be listed specifying the range by TN and ACC.
TN (Tenant Number): Set the range by entering START TN and END TN [1-63].
ACC (Access Code): Set the range by entering START ACC and END ACC [Up to six digits].
Data
ALL SELECT
Place a checkmark to delete all the listed data.
Indicate from CNT to SRV
Place a checkmark to set the parameters CNT through SRV are to be listed.
Note:
Regardless of the checkmark ON/OFF selected, STATUS field is always displayed.
CNT:
Number of lines Note 1
TN:
Tenant Number
ACC:
Access Code
CI:
Connection Status Index
SRV:
Kind of Service
SID:
Service Index
SIDA:
Service Index A
NND:
Necessary Digit
NND1:
Necessary Digit for Speed Calling
FPC:
Fusion Point Code
STATE:
Hotel Service Code
NO1:
Kind of Assignment Number
NO2:
Kind of Assignment Number
KIND:
Kind of Function
PNO:
Pattern Number for AOSP command
A/G:
Admin/Guest
LGRT:
Logical Route Number
2nd DT:
Second Dial Tone
AH:
Authorization Code