NEC SV8500 Operation And Maintenance Manual - page 531
– 484 –
CHAPTER 3
System Messages
Note:
When office data for WLAN Handset/Standard SIP process is registered by ASSDN/ASSDL command al-
though WLAN Handset/Standard SIP terminal is not accommodated, “35-F: FNC=01H (Service
Start.)” is output when SP is activated and “35-I: FNC=01H (Service Stop.)” is output when SP is
stopped.
Note:
ASSDN/ASSDL data is usually registered although
WLAN Handset/Standard SIP terminal is not accom-
modated.
Note:
It takes about five minutes (Time to detect KeepAliveTimeOut) to output “35-G: FNC=01H (Service
Stop.)”, “35-I: FNC=01H (Service Stop.)” or “35-I: FNC=02H (SIP Wireless Terminal Backup Service
Stop.)” after WLAN Handset/Standard SIP process stopped the operation.
Executed
(Active/Standby)
Reset operation from PCPro
(Active side)
•
35-F (Information), FNC=02H (Reset Indica-
tion from PCPro.), ST=02H (Active)
•
35-G(Warning), FNC=02H (ACT Change.),
ST=02H (Active)
•
35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Reset operation from PCPro
(Standby side)
•
35-F(Information), FNC=02H (Reset Indica-
tion from PCPro.), ST=02H (Active)
•
35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Changeover by a failure
•
35-G(Warning), FNC=02H (ACT Change.),
ST=02H (Active)
•
35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Changeover operation from
PCPro
•
35-F(Information), FNC=03H (ACT Change
Indication from PCPro.), ST=02H (Active)
•
35-G(Warning), FNC=02H (ACT Change.),
ST=02H (Active)
•
35-F(Information), FNC=01H (Service Start.),
ST=03H (Standby)
Mismatch in redundant setting
between
SP
and office data
•
35-G(Warning), FNC=03H (SIP Wireless Ter-
minal Backup Service Configuration Failure.)
Terms for outputting System Message
SIP Wireless Terminal
Backup
Operation/Event
System Message