MA Lighting grandMA2 User Manual - page 1017
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
29.1. Create a chaser
To create a chaser, create a sequence with at least 2 cues assigned to an executor.
1. Change the sequence to a chaser by pressing
Assign
and one of the keys associated with the executor.
2. This opens the Assign menu. Tap
Options
on the right side.
3. To change the sequence to a chaser, tap
Chaser
located below the tab
Function
.
The mini executor is now cyan.
It is possible to change the functions of keys and fader associated with the Executor. For more information,
see
.
All timing and loop information in the sequence is ignored. Commands (CMD) are executed and the
CMD Delay
is
the only timing from the sequence that is actually used. For more information, see
Start, Stop and Pause the Chaser
To
start
the chaser, press
Go+
and one of the keys associated with the executor. To fade in the chaser,
press
Go+
Time
and the fade time in seconds, for example
5
.
To
stop
the chaser, press
Off
and one of the keys associated with the executor. To fade out the chaser,
press
Off
Time
and the fade time in seconds, for example
5
.
To
pause
the chaser, press
Pause
. The chaser stops in the current step and contains the output from this step.
To start the chaser again, press
Pause
once more.
29.2. Chaser settings
The Chaser Encoder Toolbar
The
Chaser Encoder Toolbar
is useful to edit the chaser. To open the toolbar, press
Edit
and one of the keys
associated with the executor.
There are several options to set up and play back the chaser, in the cyan
Chaser Encoder Toolbar
.
1017