MA Lighting grandMA2 User Manual - page 606
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Dimmer Wheel Mode
- Tapping this opens the
Select Dimmer Wheel Mode
pop-up. This is used to select the
wheel mode of the level wheel. There are four options:
Additive
- This will allow you to use the level wheel to set the value of dimmers. It will keep the individual levels
until reaching 0% or 100%. Then it will level them out. For example: fixture 1 has a value of 50 and fixture 2 is at
60. When using the level wheel to take them both up to 100, and then back down, they both go down from 100
at the same time and at the same level.
Incremental
- This will basically do the same as 'Additive', but it remembers the individual values going beyond
0% and 100%. For example: fixture 1 has a value of 50 and fixture 2 is at 60. When using the level wheel to take
them both up to 100, and then back down, fixture 1 will start coming down first and then fixture 2 will follow when
fixture 1 is at 90.
Prop. +
(Proportional positive) - When using the level wheel to turn up the value the individual difference in value
will increase. Turning down the values will make all channels reach 0% at the same time.
Prop. -
(Proportional negative) - When using the level wheel to turn the values up the individual difference in
value will decrease. Turning up to 100% will make all channels reach 100% at the same time.
Select Dimmer Wheel Mode pop-up
Dimmer Wheel Resolution
- This is used to select the default resolution of the Level Wheel. This can also be
change on the fly by pressing the
(Encoder) key and holding it, then selecting one of the resolutions in the
pop-up - more about the
following the link.There are three different resolutions:
Fine
(0.1% of the range)
Normal
(1% of the range)
Coarse
(5% of the range)
Select Dimmer Wheel Resolution
606