MA Lighting grandMA2 User Manual - page 1035
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Important:
There is an exception to the cycle of wings. In Pan effects which consist of 2 wings, one of the wings is
inverted. Hence, fixtures run towards each other.
Single Shot:
Displays one execution of effects.
To set a single execution of an effect:
1. Tap the corresponding column.
2. The cell now displays
Yes
and the button
Single Shot
is enabled (highlighted in yellow).
-or-
To disable the single execution, tap the button
Single Shot
at the bottom of the effect editor.
3. To disable the single execution, tap and hold the cell displaying
Yes
or tap the button
Single Shot
.
Buttons in the Effect Editor
This paragraph deals with buttons contained in the effect editor and their corresponding functions:
1. Add an new attribute to an effect, tap
New
in the column
QTY
and then tap
Add
.
-or-
Tap
Add
in the lower left corner of the effect editor and the pop-up
Select Effect Attribute
opens.
Pop-up – select effect attribute
2. Select the attribute you would like to add to the effect line.
3. Then, tap
Confirm
.
A new attribute is now applied to the effect line.
4. To delete effect lines, tap
Delete
.
1035