MA Lighting grandMA2 User Manual - page 1149
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
A
command will set the timecode show in play mode.
For example if you want to play
Timecode Show 2
:
[Channel]> Go Timecode 2
If you want to play
Timecode Show 3
from a certain time and it is the
Intern
source, then the following command
can be used (3 hours and 30 minutes):
[Channel]> Go Timecode 3 Time 3h30m
The show needs to have a lengths larger than the specified time.
It can also be paused to a specific time by using the command above but with
instead of Go.
will jump to the time 0 (zero).
[Channel]> <<< Timecode 4
will jump to the end time (length in the options).
can be used to stop a timecode show.
Timecode Generator
Each
can generate a timecode signal for the session. This signal will not be output by the LTC or MIDI
ports, but it will be distributed in a session.
Tapping a timecode slot in the pool will change the encoder toolbar to look like this:
Encoder Toolbar - Timecode Generator
In the top row there are a lot of buttons. This is a short description of then from left to right:
Slot Number Info
:
This information button displays the timecode slot number and it writes
Emulated
and a frame per second if the
generator is running.
1149