MA Lighting grandMA2 User Manual - page 1315
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
48. Control the MA Network Switch from a grandMA2
The MA Network Switch is the perfect device for a full lighting control solution. The combination of console, switch
and networking devices provides the easiest solution even for complex lighting systems.
You can control the MA Network Switch by using the web interface or directly with a grandMA2 console or grandMA2
onPC. For more information about how to control the MA Network Switch by using the web interface see
This chapter explains how to control the MA Network Switch from a grandMA2 console or grandMA2 onPC. You will
find out how to add the MA Network Switch to the network configuration, configure ports, or edit groups and presets.
48.1. Add the MA Network Switch to the network configuration
Use these steps to add the MA Network Switch to the network configuration.
Requirements:
The default IP address of the switch is a 192.168.100.xxx. It is displayed at the front end display.
The default subnet mask of the switch is 255.255.255.0.
This means your PC or grandMA2 station needs to be set to a compatible IP address. For more information about
how to change the IP address see chapter
Power on (indicates by a green power LED)
Hardware connection between the MA Switch and a computer (indicates by a green or orange blinking link LED)
1. Open the MA Network Configuration.
- Press
Setup
, and tap under
Network
MA Network Configuration
.
The MA Network Configuration window opens.
1315