MA Lighting grandMA2 User Manual - page 183
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
7.3. Encoder Settings
To go to the encoder settings, press and hold the
. The pop-up is visible as long as you press the key.
The encoder bar settings has two part. The bigger part and the smaller part.
Encoder settings - bigger part
Encoder settings - smaller part
The smaller part is visible at all screens. The bigger part is visible only at screen 2.
Adjust dimmer wheel mode
The dimmer wheel mode can be set in the encoder settings or in the
Setup
, tab
User
, item
Settings
.
You can choose between four different dimmer wheel modes:
Additive
(= default):
Additive keeps the difference between the dimmer values until you reach 0% or 100%, by using the dimmer wheel.
After 0% or 100 % are reached, the values will be leveled out.
Example:
Channel 1 has a value of 50 and channel 2 is at 60. When you use the dimmer wheel to take them both up to 100,
and then back down, they both go down from 100 at the same time and at the same level.
Incremental:
Incremental keeps the difference between the dimmer values always, even if you reached 0% or 100% by using the
dimmer wheel.
Example:
Channel 1 has a value of 50 and channel 2 is at 60. When you use the dimmer wheel to take them both up to 100,
and then back down, channel 1 will start coming down first and then channel 2 will follow when channel 1 is at 90.
Prop.+
(Proportional positive):
When using the dimmer wheel to turn up the dimmer values, the difference in the dimmer values will
increase
.
Turning down the values will make all channels reach 0% at the same time.
Prop.-
(Proportional negative):
When using the dimmer wheel to turn up the dimmer values, the difference in the dimmer values will
decrease
.
Turning up to 100% will make all channels reach 100% at the same time.
183