MA Lighting grandMA2 User Manual - page 661
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Important:
This value can also be edited with live output to the fixtures. This can be done in the
when editing fixtures or via command line. When this is done for several hundred fixtures at the same
time, then this information is distributed live to all stations and NPUs in the session and this is distributed
with a small delay in the system. A progress bar is displayed. Please wait until the distribution is done
before continuing working. If this is done live for a small group of fixtures, then there should be no delay.
If the value is changed in the EditSetup then the values are updated with the show upload.
Swap:
This will swap the Pan and Tilt DMX output.
Bitmap Disable:
Turning this "On" will exclude this fixture from being affected by any Bitmap Fixtures.
Color:
Here you can add a color to the light from your fixture. This is nice for dimmers, but does not make sense for any
fixture with a color mixing system. It is like placing a color gel in front of the fixture. This color is visible in the Stage
view, Layout view, the MA 3D and can be visible in Fixture and Channel Sheets. Editing this cell opens the Select
Color pop-up:
Select color
661