MA Lighting grandMA2 User Manual - page 682
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Parameter List
When you are in the Live Setup, then you can see a button on the bottom called Parameter List. If your menu is on
screen 1 then you might be able to press the
X16
key or you can simply tap the
Parameter List
button on the
screen - even when the menu is on other screens.
This is what it could look like:
Parameter List
Again a list that is divided into two sides. The left side displays the layers in your fixture schedule. The right side
displays all the parameters in the (on the left side) selected layer.
On the left side you can only change the name and information text to each layer.
The right side has a lot more columns that you can edit. What you are editing here is connected to the parameter
and follows it. So you can re-patch the fixture and the settings will follow. The columns can be sorted. So you can
sort the list by ID number, name, address, attribute, and so on. The sorting can be both ascending and descending
order.
Next is a short description of each editable column.
Default:
This is the default value for the parameter.
Highlight:
This is the value that the parameter will get when you have activated the Highlight function. Many parameters
(other than Dimmer) have a "None" value here. This means that the parameter will not be overwritten by the
Highlight function.
Stage:
The Stage value is used when you are in the
Auto-calibration of fixture position mode
. This is typically not defined
(None value).
682