MA Lighting grandMA2 User Manual - page 1345
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
49. Control the MA xPort Nodes
The
MA 8Port Node
MA 4Port Node
MA 4Port Node WM
MA 2Port Node
MA 2Port Node WM
set an additional benchmark in MA Lighting´s networking product range as they feature the 1 Gbit/s bandwidth
capability. They allow the conversion of Ethernet data into DMX and vice versa.
It is possible to configure all xPort nodes of the grandMA2 series in a browser. Furthermore, it is possible to configure
the nodes via splitters and mergers.
Moreover, you can use a MA NSP (Network Signal Processor) as a MA 4Port Node and the MA 2Port Node from the
grandMA1 series in the grandMA2 system.
For more information on nodes see
This chapter deals with the configuration of xPort Nodes of the grandMA2 series, splitters and mergers and their
corresponding functions.
For more information read the corresponding topics.
49.1. Add the MA xPort Nodes to the Network Configuration
Follow these guidelines to add the MA xPort Nodes to the network configuration.
Requirements:
Connect the MA XPort Nodes with the console or the onPC via a network cable.
The grandMA2 console and the MA xPort Nodes have to be in the same subnet if DMX is to be output.
1. Open the
MA Network Configuration
.
-Press
Setup
and tap
MA Network Configuration
.
2. The window
MA Network Configuration
opens.
1345