MA Lighting grandMA2 User Manual - page 870
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Assign in a Load function to an executor key
Assign
Goto
Goto
[desired executor key]
Pressing the the "Goto" key twice will give the "Load" command.
Command Example
Functions can be assigned using the command line.
This is the general syntax:
Assign [function] (at) [location]
The location needs to be a specific physical key associated with an executor. The keys are called "ExecButtons".
They are numbered. The key below the fader and the single key for executors without faders are named
"ExecButton1". The key right above the fader is "ExecButton2" and the top key is called "ExecButton3".
To assign the ToFull function to the top key associated with executor 5 on executor page 8 you would need to type
the following command
[Channel]> Assign ToFull ExecButton3 8.5
Change Fader function
It might be possible to change the function of the fader. This depends on what type of object an executor has. They
are changed just as the executor keys - by tapping the onscreen representation in the Assign menu (see above).
The Select pop-up could look like this:
Small Select Function (Executor Fader) pop-up
The pop-up might present a smaller selection. This depends on the object on the executor.
870