MA Lighting grandMA2 User Manual - page 1076
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Pan/Tilt:
Converts the XYZ values to pan and tilt and stores them.
Set Position Modes in a Sequence
Set a default position mode in the Assign Menu of a sequence for the entire sequence.
Requirement:
Assign a sequence to an executor
1. Open the
Assign Menu
of the sequence:
-Tap
Assign
and press the executor you have saved the sequence on.
-The
Assign Menu
opens.
-Tap
Options
on the right of the menu.
Set a default position mode in a sequence
2. Tap the button
Forced Pos. Mode
in the column
Tracking
and the
pop-up Select Forced Position Mode
opens.
Select position mode
3. Tap the position mode you would like to set as the default of the sequence.
1076