MA Lighting grandMA2 User Manual - page 988
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Display all fixtures with attributes that currently have values in the DMX tester. And on the attribute mask it displays all
the attributes that have values in the DMX tester.
Fade/Delay - both:
This will display all the fixtures and attributes with individual fade or delay timing in currently active cues or is active
in the programmer.
Effect - both:
Displays all fixtures and attributes currently using effect parameters at the output.
In Object... - both:
This will give you the fourth column. Here you will get a button that opens the
Select Object pop-up
. Here you can
select a specific Group, Effect, Preset, Sequence or World as your object. This will then display all fixtures or
attributes currently using the defined object.
The pop-up could look like this:
Select Object pop-up
In this pop-up there are five different tabs with the different object types you can select. In each tab you will find the
different object that exists in your show.
Look - both:
This can be used to display fixtures and attributes that will be affected by the same options as when using the Look
options when storing.
988