MA Lighting grandMA2 User Manual - page 815
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Encoder Toolbar - Edit Sequence - Page 1 Basics
The top row have some buttons and information.
Starting from the left there is an information "button" that shows the executor number, the sequence number and
name, and the cue number and name. It is not actually a button. Next to this is a button that enters or exits the
"Edit" mode - This will also change the Encoder Toolbar. Next are six buttons that can be used to control the
sequence playback - Please read the
for more on this. The last button in the top row is
used to change between three different pages for the bottom encoder row.
The image above shows the first page - called "Basics". This gives access to change the: Trigger, Trig Time, Mode,
and Loop. They are each assigned to one of the four encoders. The settings will change for the selected cues
(rows).
The next page is called "Fade Delay" and could look like this:
Encoder Toolbar - Edit Sequence - Page 2 Fade Delay
The top row is the same. It is only the bottom encoder row that changes.
Now the encoders control Fade, Out Fade, Delay, and Out Delay.
The third page is called "Part cont." and could look like this:
Encoder Toolbar - Edit Sequence - Page 3 Part cont.
Now the encoders control Snap Percent, CMD, CMD Delay, and Info.
Edit the Sequence
The last way to see the cue sequence is by editing the sequence.
This is a command line action. The syntax is:
Edit Sequence [number]
This can be done using the keys or by writing in the command line input.
The result is that the Sequence Editor pop-up appears. It could look like this:
815