MA Lighting grandMA2 User Manual - page 856
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Selected Executor number 1
In the image above the left executor is the selected executor.
The selected executor is used by the Master Section and the two 100mm faders - see more in the
The selected executor is also often used in sheets.
It is possible to select more than one executor, but the first one selected is a little bit more selected then the others
- it is the one displayed in sheets and in the Master Section. The three big
Go+
,
Go-
and
Pause
keys
executes the commands on all selected executors. Commands not sent to a specific executor is executed on all the
selected executors. For instance
Store Cue 21
will store the cue on all selected executors.
Selecting multiple executors can be done by keeping the Select key pressed while pressing executor keys. It is also
possible using the command line. For instance
Select
Exec
1
+
2
Please
will select both executor 1 and
2.
Executor Encoder Toolbar
If the executor have a sequence assigned then the Encoder Toolbar might change to look like this:
Encoder Toolbar - Executor
This toolbar appears if you have opened the sequence editor and closes the editor.
The top row have some buttons and information.
Starting from the left there is an information "button" that shows the executor number, the sequence number and
name. It is not actually a button. Next to this is a button that enters or exits the Sequence Editor - This will also
change the Encoder Toolbar. Next are six buttons that can be used to control the sequence playback - please read
more about these controls in the
.
856