MA Lighting grandMA2 User Manual - page 1040
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
To create an effect in the programmer:
1. Select fixtures.
2. Then, select a preset type in the preset control bar.
For more information see
.
3. Then, tap
Effect Layers
in the layer bar.
For more information see
Layers in sheets – Channel sheet and fixture sheet
.
4. Select a layer.
5. Now, select the attribute of your effect:
To select, tap and swipe
Link Feature
.
For more information on the different link settings see
.
Important:
An effect starts as soon as it has been select, since all effect layers have default values.
5. To adjust the values of a layer, turn the encoder left or right.
Important:
If you create an effect in the programmer, the layer
ID
does not have a red marker.
ID
only displays a
red marker if the effect was started in the effect pool.
6. Adjust the values of the preset type:
-Tap
Special Dialog
.
-The
Effect Value
opens.
Pop-up – effect value
1040