MA Lighting grandMA2 User Manual - page 48
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Location Ethernet ports
Ethernet Port 1
Information:
The Ethernet port 1 is called eth0 in the grandMA2 software.
Information:
The Ethernet port 1 can be used for the following network protocols:
- MA-Net2
- ETC Net2
- Pathport
- sACN
- Shownet
- Kinet1
- CITP
- PSN
Requirement:
STP (shielded twisted pair) cable with RJ45 connector, min. Cat 5e.
To connect Ethernet port 1:
1. Connect one end of an Ethernet cable to the
Ethernet 1
port.
2. Connect the other end to a suitable switch.
3. Connect other grandMA2 equipment to the switch and turn on the power on the switch.
Ethernet is connected to port 1.
Ethernet Port 2
Information:
The Ethernet port 2 is called eth1 in the grandMA2 software.
48