MA Lighting grandMA2 User Manual - page 607
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Channel Page Width
- Opens the
Select Channel Page Width
pop-up. Here the width of the channel pages can
be selected. The options are:
Default
- This will add the amount of your current console.
Half Page
(15 faders) - This will scale down a grandMA2 full-size or grandMA2 onPC to match a grandMA2 light or
grandMA2 ultra-light.
Full Page
(30 faders) - This will not add more faders to your grandMA2 light or grandMA2 ultra-light, but it will
spread it out as if it was a grandMA2 full-size.
Select Channel Page Width pop-up
This cannot add more faders to your console. If there only are 15 faders then you do not get 30 - but you can
scale down a grandMA2 full-size.
Dynamic Channel Page Shows Only Selected
- When this is On then the console will only display the selected
fixtures in "Dynamic Channel Pages" - read more about the Dynamic Channel Pages in the
At Normal Percent
- Here you can define what percent should be considered "
". This is used when the
At
key is pressed twice.
Single Digit Value
- All numeric value input below 10 will be a multiplication of 10; for example: channel 1 at 5 =
channel 1 gets value 50.
Max. Program Time
- This is the maximum allowed Program time for the
Program Time Special Master
. Follow
this link
to read more about the Program Time.
Max. Exec Time
- This is the maximum allowed Executor time for the
Executor Time Special Master
. Follow this
link
to read more about the Executor Time.
Special Fader Buttons
- Here you can Enable or Disable the extra buttons above the 100mm faders. Follow this
link
to read more about this area.
Disable View Button and View CLI
- With this option activated Views and Viewbuttons will not interact with the
command line anymore. For example hitting the store button to store a group and realizing you have to change
the View to get a group pool would not accidently store a view.
Patch Column Readout is absolute DMX address
- This will set the Patch columns to display the absolute DMX
address instead of a universe and address split. For example with this On you will see the DMX address "2.1"
(universe.address) as "513".
607