MA Lighting grandMA2 User Manual - page 1054
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Important:
All adjustments made with the help of the encoder toolbar for live effects are taken into the live
programmer. Thus, being taken over into the next cue if stored.
4. Adjust the values by turning the encoders.
Important:
If the value Low is set to 0, tapping
Prop.
to toggle it to
Incr.
enables the encoders.
5. If you have more than two effects in the programmer, tapping
Select Effect
opens the pop-up
Select
Effect
.
Pop-up – select effect
To edit the values of an effect, select the effect in the pop-up first.
If you have less than three effects in the programmer, tapping
Select Effect
toggles between the different
effects.
6.
Edit Program.
indicates that editing currently takes places in the programmer.
To open the effect editor, tap
Edit Progr.
It is then possible to edit the actual effect.
For more information see
Use predefined effects – effect editor
7. To toggle between different modes, tap
Low/High Mode
.
8. To toggle between relative and absolute values, tap
Relative <> Absolute
.
9. Change the direction of the effect:
-Tap
Direction <>
.
10. To turn off the effect and remove it in the programmer, tap
Off Effect
.
11. To take the release value into the programmer, tap
Release Effect
.
12. To take stomp values into the programmer, tap
Stomp Effect
.
13. To toggle the functionality of encoders, tap
Basics 1 of 2
.
For more information on the different functionalities see
Important:
If you accidentally tap anywhere, the encoder toolbar for live edit disappears. To regain it, tap the cell
with displaying the name of the effect pool.
1054