MA Lighting grandMA2 User Manual - page 1020
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
Select Speed Group
Individual speed
lets the chaser run with the speed set by the
Speed Encoder
Speed 1
through
Speed 15
limits the speed of the chaser by a
Speed Master
. This is useful to keep the chaser in
sync with other chasers and effects. For more information, see
The
BPM
option measures the Beat from the Audio In signal. For more information, see
.
To enable or disable the
CMD
field in the Chasers Executor sheet, tap the
Cmd Disable
button. If the CMD is
disabled, the
CMD Disable
turns cyan and all the Commands in the
CMD
row of the
Executor sheet
are displayed
in red.
There is also the opportunity to test the command in the
CMD
field. If a current step is present and a command is
entered in the
CMD
field, tap
Test Cmd
to test the function.
Sometimes the chaser has to keep the beat but double or half the speed.
To half of the current value, tap
Half Speed
.
To double the current value tap
Double Speed
.
Speed 1:1
resets the speed to the value set by the Speed Encoder, the Speed Master or the Audio In,
depending on the selected Speed Group.
Another option is to tap
Speed
. This opens the pop-up
Select Speed Factor.
This is useful to multiply or divide the
speed by 2, 4, 8, 16, or 32 of the selected Speed Group.
To exit the
Edit Chaser
window tap
The Playback Buttons
The buttons to start, stop and pause the chaser:
To start the chaser, tap
. This starts the chaser from the first cue to the last, and then loop to the first again.
To start the chaser, running from the last cue to the first, and then loop to the last again, tap
.
To stop the chaser, tap
.
To pause the chaser in the current step, and keep the actual output, tap
. Tap the
to start the chaser
again, from the current step.
To stop the chaser and step thru the steps one by one, tap
or
.
The Encoders
1020