MA Lighting grandMA2 User Manual - page 1211
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-30 | tech.support (at) malighting.com | www.malighting.com
Version 3.3
1
40.4. Work with RDM parameters
After the RDM is turned on and an RDM fixture is discovered, you can:
Send RDM commands to the RDM fixture see
Add RDM parameter used by the fixture see
Delete previous added parameters see
Set RDM parameters
The following examples will explain the set parameter function with the example of changing the fixture mode.
There are two ways to set RDM parameter.
Requirement:
RDM is turned on and at least one RDM fixture is discovered.
Way A:
1. Open the RDM sheet. Tap on an empty space in the user defined area, tap at
Sheets
and then at
RDM
.
2. The
RDM sheet
opens.
RDM sheet
3. Scroll with the scroll bar to the column DMX PERSONALITY and tap at the cell you like to change the fixture
mode. Press the screen encoder.
4. The
Select RDM Mode
pop-up opens.
Select RDM Mode pop-up
5. Tap at the mode the fixture should use.
1211