NEC Univerge SV8100 Programming Manual - 11-09 : Trunk Access Code
Issue 11.0
UNIVERGE SV8100
2 - 102
Program 11 : System Numbering
Description
Use
Program 11-09 : Trunk Access Code
to assign the trunk access code (normally 9).
The trunk access code can be set from 1~8 digits which is defined to type 3 and 4 in
Program 11-01. This is the code extension users dial to access Automatic Route
Selection. The individual Trunk Access Code is used when Trunk Group Routing is
desired for an outgoing line.
Program 11 : System Numbering
11-09 : Trunk Access Code
Level:
IN
Caution!
The digit 9 is defined in Program 11-01 as Dial Type 3 with the Number of Digits
Required set to 1. If you change the trunk access code in Program 11-09, you
must make the corresponding changes in Program 11-01.
Input Data
Item
No.
Trunk Access
Code
Description
Default
Related Program
01
Dial
(Up to four digits)
Assign the trunk access
code (normally 9). This is
the code extension users
dial to access Automatic
Route Selection.
9
11-01 : System
Numbering
14-01 : Basic Trunk
Data Setup
14-05 : Trunk Group
14-06 : Trunk Group
Routing
21-02: Trunk Group
Routing for
Extensions