NEC Univerge SV8100 Programming Manual - page 54
Issue 11.0
UNIVERGE SV8100
2 - 12
Program 10 : System Configuration Setup
09
Dial Information Element
ISDN Protocol definition (Only when
Dialing Sending Mode (10-03-08) is set
for 1 (Overlap Sending)
0 = Keypad Facility
1 = Called Party Number
0
10
Master/Slave System
If set to 0, system is synchronized to the
network clock. If set to 1, system is not
synchronized to the network clock. (For
NW Mode)
0 = Slave System
1 = Master System
0
11
Networking System No. (for NW
Mode)
0~50
0
13
Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the system
considers this as Loss-Of-Signal and
the PRTA does not come up.
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
2
14
--- Not Used ---
15
--- Not Used ---
16
PRI Service Two B-Channel
Transfer
Turn On or Off the ability to use the
ISDN-PRI 2 B-Channel Transfer
service.
0 = Off
1 = On
0
17
ISDN Ringback Tone
If Telco does not provide ringback tone,
SV8100 can if 10-03-17 is set
to 1 (Enable).
0 = Disable
1 = Enable
1
18
Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
2
19
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for the
ISDN circuit.
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
1
Item
No.
Item
Input Data
Default