NEC Univerge SV8100 Programming Manual - page 888
Issue 11.0
UNIVERGE SV8100
2 - 846
Program 90 : Maintenance Program
63
0
0
SIP-MLT
trouble
information.
1. The trouble occurred in
the SIP-MLT relation.
2. The DSP resource could
not be acquired at
incoming/outgoing.
3. The negotiation with
VoIPDB failed.
1. The packet loss
occurred on the
network or the
wiring cutting
occurred.
2. DSP of VoIP not
acquired.
Confirm whether each
equipment such as
wirings and HUB is
normal.
WAR
64
1
0
VoIPDB LAN
Link Error.
The link of LAN of VoIPDB
came off.
1. LAN cable
defective.
2. Connected HUB
broken.
3. Defective
CD-CP00-US.
1. Confirm LAN
connector and
wiring.
2. Check with maker on
uncertain points.
When the
connection
returns
normally, the
error is
recovered.
ERR
REC
65
0
0
VoIPDB
trouble
information.
When DSP of VoIPDB
notifies Error.
PZ-32IPLA
defective.
1. Possibility of
defective hardware.
2. Check with maker on
uncertain points.
WAR
66
2
0
SIP extension
License Error.
More than the number of
licenses to which the SIP
extension terminal was
turned on at REGISTER.
Wrong number of
licenses.
1. Confirm number of
licenses for SIP
extension terminals.
2. Check with maker on
uncertain points.
When the
number of
registration of
SIP extension
terminals falls
below the
number of
licenses.
WAR
67
0
0
SIP illegal
packet
received.
The system received an
illegal packet.
A client or network
is in an illegal state.
Check with maker on
uncertain points.
INF
68
2
0
VoIP DSP All
Busy Alarm
1. Provides alert when all
DSP resources are being
used.
2. Used to troubleshoot or
alerting when upgrade is
needed.
Not enough DSP
resources in
system.
Install PZ-VMDB with
more DSP resources.
69
--- Reserved ---
70
2
0
SIP Stack
Reconfig
Report
71
2
0
CID Buffer
Threshold
When the number of CID
records is over the limit,
CID buffer threshold alarm
(71) can be reported.
72~79
--- Reserved ---
80
1
0
NetLink start
error.
The error occurred when
NetLink started.
Defective
CD-CP00-US.
1. Possibility of
defective hardware.
2. Check with maker.
ERR
81
2
0
NetLink call
trouble
information.
1. The trouble occurred in
the NetLink relation.
2. The DSP resource was
not acquired at
incoming/outgoing.
PZ-32IPLA DSP
not acquired.
1. Confirm wiring and
system data settings.
2. Check with maker on
uncertain points.
WAR
Table 2-20 Description of Alarm (Continued)
Alarm
No.
Type
Report
Name
Content of Alarm
Cause
Action
Recovery
Alarm
Status