NEC Univerge SV8100 Programming Manual - page 51
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 9
For BRIA PKG Setup
ISDN Line Number
01~04
Item
No
Item
Input Data
Default
01
ISDN Line Mode
0 = Not Used
1 = T-Point
2 = S-Point (Not used)
3 = NW Mode (Leased Line)
4 = NW Mode (Interconnected Line)
5 = NW Mode (Interconnected Line,
Fixed Layer1 = NT)
6 = S-Point (Leased Line) (Not used)
1
02
Logical Port Number
The starting port number of a BRI
line is displayed. Two logic ports are
automatically assigned to a BRI line.
0 = Not Used
1 = T-Point (1~200)
2 = S-Point (1~512) (Not used)
3 = NW Mode (Leased Line) (0)
4 = NW Mode (Interconnected Line)
(0)
5 = NW Mode (Interconnected Line,
Fixed Layer1 = NT) (0)
6 = S-Point (Leased Line) (1~512)
(Not used)
0
03
Connection Type
0 = Point-to-Multipoint
1 = Point-to-Point
0
04
Layer 3 Timer Type
Each timer value of Layer 3 is set up
for every type using Program 81-06
(T-Bus).
1~5
1
05
CLIP Information Announcement
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
0 = Disable
1 = Enable
1
06
--- Not Used ---
07
--- Not Used ---
08
Dial Sending Mode
ISDN Protocol definition
0 = Enblock Sending
1 = Overlap Sending
1
09
Dial Information Element
ISDN Protocol definition
[Only when Dialing Sending Mode
(10-03-08) is set for 1 (Overlap Sending]
0 = Keypad Facility
1 = Called Party Number
0