NEC Univerge SV8100 Programming Manual - page 196
Issue 11.0
UNIVERGE SV8100
2 - 154
Program 14 : Trunk, Basic Setup
07
DP to DTMF Conversion Options
Determine how a user can convert a
Dial Pulse (DP) call to a DTMF call. For
each trunk, set the type of DP to DTMF
conversion required. There are three
conversion options: Automatic (0),
Automatic and Manual (1), or Manual
(2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit. In addition, the
user can dial
#
to switch a DP trunk to
DTMF dialing.
Manual:
Users can dial
#
to switch a DP trunk
to DTMF dialing.
0 = Automatic
1 = Automatic and
Manual
2 = Manual
2
21-01-03
08
Answering Condition
0 = Polarity Reversing
(Polarity)
1 = Polarity Reversing or
Timer (Int Digit)
1
21-01-03
09
Busy Tone Detection
0 = Disable (No)
1 = Enable (Yes)
0
10
Caller ID
Enable/Disable ability of a trunk to
receive Caller ID information.
0 = No
1 = Yes
0
11
Next Trunk in Rotary if No Dial Tone
Enable/Disable the system ability to
skip over a trunk if dial tone is not
detected. This option pertains to calls
placed using Speed Dial, ARS, Last
Number Redial or Save Number
dialed. It does not pertain to line key or
Direct Trunk Access calls.
0 = Disable (No)
1 = Enable (Yes)
0
12
Detect Network Disconnect Signal
0
= Disable (No)
1
= Enable (Yes)
1
13
Trunk-to-Trunk Limitation
0
= Disable (No)
1
= Enable (Yes)
0
Item
No.
Item
Input Data
Default
Related
Program