NEC Univerge SV8100 Programming Manual - page 809
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 767
17
Jitter Buffer Mode
Setting 2 (Self adjusting-silent
period-is not valid for IPLB. If this
value is set, the system will
operate as Setting 3.
1 = Fixed
2 = Adaptive during silence
3 = Adaptive Immediately
3
18
VAD Threshold
0~30 (-19dB~+10dB)
0 = Self adjustment
1
= -19dB (-49dBm)
:
2
= 0dB (-30dBm)
:
29 = 9dBm (-21dBm)
30 = 10dBm (-20dBm)
20
19
Idle Noise Level
Not used by IPLB.
5000~7000
(-5000dBm~
-7000dBm)
7000
20
Echo Canceller Mode
Not used by IPLB. Echo
canceller setup is 84-31 for
IPLB.
0 = Disable
1 = Enable
1
21
Signal Limiter
Not used by IPLB.
1 = Mode 0
2 = Mode 1
3 = Mode 2
4 = Mode 3
5 = Mode 4
6 = Mode 5
1. There is no limitation.
2. The limitation is the
maximum.
3. Limitation size
4. It is limiting it.
5. Limitation smallness
6. The limitation is minimum.
6
22
Echo Canceller NLP Mode
When the NLP mode is turned
on, the voice with low level is
replaced with the NLP noise. As
a result, a low echo of the level is
usually removed compared with
the conversation level.
Not used by IPLB. Echo
canceller setup is 84-31 for
IPLB.
0 = 2-wire and 4-wire
1 = 2-wire only
(2-wire means analog and
4-wire means digital).
1
Input Data (Continued)
Item
No.
Item
Input Data
Default