NEC Univerge SV8100 Programming Manual - page 95
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 53
Description
Use Program 10-32 : PRI Networking Channel Limitation to assign the number of
B-channels to be used for each ISDN blade. This allows for fractional PRIs when
used with multiple site networking. If this program is limited to less than "23" on one
side of the network, then it also limits both inbound and outbound network calls. For
example, when you select 10 channels then only channels 1 to 10 will be available. If
a call is attempted on channels 11 to 30 the caller will receive busy tone. This also
applies on the other side of the network as well.
The setting is for each slot within the SV8100. Ensure that you select the correct slot
before making any changes.
This program will not affect a PRI card set as Trunk or Station mode.
(This program requires software Version 4000 or higher.)
Conditions
None
Feature Cross Reference
None
Program 10 : System Configuration Setup
10-32 : PRI Networking Channel Limitation
Level:
IN
Input Data
Slot Number
1~24
Input Data
Item
No.
Item
Input Data
Default
01
Maximum
Channels
Set the maximum
number of channels
that can be used
with PRI NetLink.
1~23
23