NEC Univerge SV8100 Programming Manual - page 53
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 11
For PRTA PKG Setup
ISDN Line Number
01~24
Item
No.
Item
Input Data
Default
01
ISDN Line Mode
0 = Not Used
1 = T-Point
2 = S-Point (Not used)
3 = NW Mode (Leased Line)
4 = NW Mode (Interconnected Line)
5 = NW Mode (Interconnected Line,
Fixed Layer1 = NT)
6 = S-Point (Leased Line) (Not used)
1
02
Logical Port Number
The start port number of a PRI line is
displayed.
0 = Not used
1 = T-Point (1~200)
2 = S-Point (1~512) (Not used)
3 = NW Mode (Leased Line) (0)
4 = NW Mode (Interconnected Line)
(0)
5 = NW Mode (Interconnected Line,
Fixed Layer1 = NT) (0)
6 = S-Point (Leased Line) (1~512)
(Not used)
1
03
--- Not Used ---
04
Layer 3 Timer Type
Each timer value of Layer 3 is set up
for each type in
Program 81-06 (T-Bus)
1~5
1
05
CLIP Information
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
0 = Disable
1 = Enable
1
06
Length of Cable
0 = Level 1
1 = Level 2
2 = Level 3
3 = Level 4
4 = Level 5
2
07
--- Not Used ---
08
Dial Sending Mode
ISDN Protocol definition
0 = Enbloc Sending
1 = Overlap Sending
0