NEC Univerge SV8100 Programming Manual - page 230
Issue 11.0
UNIVERGE SV8100
2 - 188
Program 15 : Extension, Basic Setup
44
Using
Standard SIP
Display for
CPN
0 = Disable
1 = Enable
0
This Program is used to
Enable or Disable the
system to send INVITE
Fromtag Display attribute
which is sent from a
standard SIP terminal as
CPN to ISDN and if there
is no Display attribute
from standard SIP
terminal, the system will
not refer to either PRG
21-12-01 or 21-13-01 and
no CPN will be sent.
45
NAT Plug &
Play
0 = Disable
1 = Enable
0
Select sending RTP port
number to remote router.
(0) uses result from
negotiation result, (1)
from received RTP
packet. Effective only
when 10-46-14 is to NAT
Mode.
10-46-14
46
Door Phone
Number
(Read Only)
0 = Not assigned
1 ~ 8 = Door Phone No.
0
Indicates automatically
assigned IP Door Phone
Number after system
registers the Door Phone
port. System assignes the
number not to duplicate with
the Door Phone connected
to 2PGDAD. (Read Only)
10-03
(DLCA)
PGD
47
Registration
Expire Timer
for NAPT
0 = Disable
60 ~ 65535(sec)
180
On a per station basis, this
setting defines the SIP
registration expiry timer. This
setting only applies to
DT700 stations connected
via NAPT. If this value is set
to 0, for a NAPT terminal,
the value in PRG 84-23- 01
is applied.
Note: Version 9000 or higher
is required.
10-46-14
Item
No.
Item
Input Data
Default
Description
Related
Program