NEC Univerge SV8100 Programming Manual - Program 34 : Tie Line Setup
SV8100 Programming Manual
2 - 443
Program
34
Description
Use Program 34-01 : E&M Tie Line Basic Setup to define the basic settings
for each E&M Tie line.
Program 34 : Tie Line Setup
34-01 : E&M Tie Line Basic Setup
Level:
IN
Input Data
Trunk Port Number
001~200
Item
No.
Item
Input Data
Default
Description
Related
Program
01
DID/E&M Start
Signaling
0 = 2
nd
Dial Tone
1 = Wink
2 = Immediate
3 = Delay
1
Set the start signaling mode for
DID and Tie trunks. DID and
Tie trunks can use either
immediate start or wink start
signaling.
22-02
02
Receive Dial Type
for E&M Tie Line
0 = DP
1 = DTMF
2 = MF
1
10-09
03
E&M Dial-In Mode
0 = Specify Extension
Number (Intercom)
1 = Use Conversion
Table (NTT)
0
Determine if the incoming Tie
Line call should be directed as
an intercom call or if it should
follow the DID Translation
Table in Program 22-11.
22-11
04
E&M Line Dial Tone
0 = Disable (No)
1 = Enable (Yes)
1
Enter 1 if the Tie Line should
send dial tone to the calling
system after the call is set up.
Enter 0 if the Tie Line should
not send dial tone.
05
System Toll
Restriction
0 = System
1 = Each extension
0
Determine if an incoming Tie
Line call should be subject to
Toll Restriction.
21-05