NEC Univerge SV8100 Programming Manual - page 887
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 845
57
2
0
IP Collision
Error
Collision(01) indicates the
address programmed in
10-12-01 has been
duplicated. Collision (02)
indicates the address
programmed in 10-12-09
has been duplicated.
Collision(03) ~
Collision(10) indicates the
addresses programmed in
84-26-01 have been
duplicated. (03) is GW1 ~
(10) is GW8.
An IP address
programmed in
either 10-12-01, 10-
12-09 or 84-26 is
duplicated
somewhere on the
same segment of
the network. The
system will check
every 5 minutes
and is not a
programmable
increment.
Confirm that the
addresses assigned in
10-12-01, 10-12-09,
and 86-26 are not
duplicated anywhere
else on the network.
58
2
0
Failure of
Outbound IP
Connection
01: Programming session
is already active.
02: Not setting of IP
Address or Port.
03: Caller ID does not
match.
10: Cannot get IP Address.
11: Socket Open Error.
12: Socket Port Setting
Error.
13: TCP Session Timeout.
59
--- Reserved ---
60
2
0
SIP
Registration
Error
Notification.
1.The registration of the
SIP trunk to the SIP
server failed.
2.The registration of the
SIP trunk to the SIP
server failed in the
authentication.
3.There is no response
from the SIP server to
the SIP registration
request.
1. The system data
setting is wrong.
2. The router
setting is wrong.
3. LAN link error .
4. Net side trouble.
1. Confirm the following
system data setting --
PRG 10-12, 10-28,
10-29, 10-30, and 10-
36.
2.Confirm the setting of
routers.
3.Confirm whether
abnormality occurs
on the net side.
4. Confirm the
authentication
system data setting
5. Confirm wiring and
the system data
setting. Inquire on
uncertain points of
the maker.
The error is
recovered
when normally
connecting it.
ERR
REC
61
0
0
SIP extension
trouble
information.
1. Failed registration of the
SIP extension terminal.
2. The SIP extension
terminal DSP was not
acquired:
• At registration of SIP
extension terminal to
SV8100.
• When you cannot
acquire the DSP
resource when it is
sent.
1. The registered
port is used by
other extension.
2. The license is
insufficient.
3. DSP of VoIPDB
not acquired.
1. Confirm wiring and
system data setting.
2. Confirm whether
each equipment
such as access
points works
normally.
ERR
REC
62
0
0
DtermIP
trouble
information.
The error occurred by the
DtermIP relation.
• When the error occurs
while communicating
with VoIPU or DtermIP.
• When it becomes
impossible to do the
communication between
SV8100 and DtermIP
• When failing in the
acquisition of DSP.
1. The packet loss
occurred on the
network or the
wiring cutting
occurred.
2. DSP of VoIP not
acquired.
Confirm whether each
equipment such as
wirings and HUB is
normal.
ERR
REC
Table 2-20 Description of Alarm (Continued)
Alarm
No.
Type
Report
Name
Content of Alarm
Cause
Action
Recovery
Alarm
Status