NEC Univerge SV8100 Programming Manual - page 605
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 563
08
Forced Unscreened Transfer
(Forced UTRF)
Enable/Disable Automated Attendant Forced
Unscreened Transfer for the Subscriber Mailbox. If
enabled, each Screened Transfer (TRF) to the
extension is converted to an Unscreened Transfer
(UTRF). If disabled, Screened Transfers from the
Automated Attendant occur normally.
0 = No (Disable)
1 = Yes (Enable)
0
09
Auto Time Stamp
Enable/Disable Auto Time Stamp for the Subscriber
Mailbox. If enabled, after the subscriber listens to a
message SV8100 InMail announces the time and
date the message was left. Auto Time Stamp also
announces the message sender (if known).
A subscriber also can enable Auto Time Stamp
from their mailbox.
0 = No (Disable)
1 = Yes (Enable)
0
10
System Administrator
(System Admin)
Designate the Subscriber Mailbox as a System
Administrator. This allows the subscriber to use the
options after logging onto their mailbox.
0 = No (Disable)
1 = Yes (Enable)
0
11
Dialing Option
Provide additional dialing options for Next Call
Routing Mailbox calls (see Next Call Routing
Mailbox below). If enabled, a caller who accesses
the Subscriber Mailbox to leave a message can dial
any option in the Next Call Routing Mailbox Dial
Action Table. If disabled, the caller can dial only 0
(to use the Next Call Routing Mailbox 0 action).
0 = No (Disable)
1 = Yes (Enable)
0
12
Next Call Routing Mailbox
(Next CR Mbox)
Assign a Next Call Routing Mailbox to the
Subscriber Mailbox. This provides callers with
additional dialing options while listening to a
Subscriber Mailbox recorded or default greeting.
The digits the caller can dial depends on the setting
of the Next Call Routing Mailbox and Alternate Next
Call Routing Mailbox options.
Call Routing Mailbox
Number (0~32)
No entry (entered by
pressing CLEAR)
1
(Call Routing
Mailbox 01)
By default, Call
Routing Mailbox
numbers are
01=16.
13
Directory List Number
Specify the Directory List number to which the
Group Mailbox belongs.
0 = None
1~8 = List Number
= All
0
14
Voice Prompt Language
Refer to
.
1
15
Enable Paging
0 = No
1 = Yes
0
Input Data (Continued)
Item
No.
Item
Input Data
Default