NEC Univerge SV8100 Programming Manual - page 309
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 267
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display
Messages. There are 20 alphanumeric messages, with up to 24 characters. Use the
following chart when programming messages.
Program 20 : System Option Setup
20-16 : Selectable Display Messages
Level:
SA
Use this keypad
digit . . .
When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
Á À Ã Ç É Ê ì ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “
#
$ % & ’ ( ) ô Õ ú ä ö ü
Enter characters:
+ , - . / : ; < = > ?
B
E
S
•
¢ £
#
#
= Accepts an entry (only required if two letters on the same key are
needed – ex: TOM). Pressing
#
again = Space. (In system programming
mode, use the right arrow soft key instead to accept and/or add a space.)
CONF
Clear the character entry one character at a time.
HOLD
Clear all the entries from the point of the flashing cursor and to the right.