NEC Univerge SV8100 Programming Manual - page 93
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 51
Description
Use Program 10-31 : Network Keep Alive Setup to set the interval and retry count
of the AspireNet networking keep alive message. The keep alive is used for ISDN and
IP networking.
The keep alive message is automatically responded to by the destination SV8100/
UX5000, if the response is not received the retry count will start. If a response is not
received within the number of retries, the networking link will be taken out of service.
When the link is taken out of service:
Any calls that are in progress will be released.
Park Hold orbits will be released.
No further Park Hold information will be sent until the link is active.
The link will automatically become active when the next keep alive response is
received.
(This program requires software Version 4000 or higher.)
Program 10 : System Configuration Setup
10-31 : Network Keep Alive Setup
Level:
IN
Input Data
Item
No.
Item
Input Data
Default
01
Keep Alive
Interval
This program is used
to set the interval of
the Keep Alive timer.
The SV8100/
UX5000 does not
send Keep Alive
when this item is set
to 0. If this entry is
greater than 0,
networked PRI
spans which are
using Kentrox DSUs
will not re-sync when
removed from
service, then
returned to service.
0~65535 seconds
0