NEC Univerge SV8100 Programming Manual - page 274
Issue 11.0
UNIVERGE SV8100
2 - 232
Program 20 : System Option Setup
06
Preselection Time
When a multiline terminal user
preselects a line key, the system
remembers the preselection for this
time.
0~64800 (sec)
5
07
Time and Date Display Mode
Set how the Time and Date appear on
display telephones. There are eight
display modes.
1~8
Type 1 = (12 hour) 10 MAR TUE 3:15PM
Type 2 = (12 hour) 3:15PM MAR 10 TUE
Type 3 = (12 hour) 3-10 TUE 3:15 PM
Type 4 = (12 hour) 3:15PM TUE 10 MAR
Type 5 = (24 hour) 10 MAR TUE 15:15
Type 6 = (24 hour) 15:15 MAR 10 TUE
Type 7 = (24 hour) 3-10 TUE 15:15
Type 8 = (24 hour) 15:15 TUE 10 MAR
3
08
LCD Display Holding Time
0~64800 (sec)
5
09
Disconnect Supervision
Enable/Disable disconnect
supervision for the system trunks.
0 = Disable (Off)
1 = Enable (On)
1
10
Time Before Shifting to
Power-Saving Mode
0 = No shift
1 = 1 minute
2 = 2 minutes
3 = 4 minutes
4 = 8 minutes
5 = 16 minutes
6 = 32 minutes
7 = 64 minutes
0
15-02-18
11
Handsfree Microphone Control
Control the setting for Multiline
Terminal Handsfree microphone after
being disconnected and reconnected.
If set to 0, the microphone is always
off when the terminal is reconnected.
If set to 1, the microphone remains in
the same state it was in when the
terminal is reconnected.
0 = Off
1 = On
1
12
Forced Intercom Ring (ICM Call
Type)
Enable/Disable Forced Intercom
Ringing. If enabled, incoming
Intercom calls normally ring. If
disabled, Intercom calls
voice-announce.
0 = Disable (Voice)
1 = Enable (Signal)
0
13
--- Not Used ---
Input Data (Continued)
Item
No.
Item
Input Data
Default
Related
Programming