NEC Univerge SV8100 Programming Manual - page 63
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 21
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on
the CD-CP00-US for either DTMF receiving or dial tone detection. The CD-CP00-US
has 32 circuits initially, and an addition 64 circuits are added when a PZ-BS10 is
installed. These are used as follows:
Extension
DTMF receiver for single line telephone
Trunk
DTMF receiver for analog trunks, dial tone & busy tone detection
for analog trunks
Program 10 : System Configuration Setup
10-09 : DTMF and Dial Tone Circuit Setup
Level:
IN
Input Data
Circuit/Resource Number
01~160
Item
No.
Input Data
Default Setting
01
0 = Common Use
1 = Extension Only
2 = Trunk Only
The CD-CP00-US has 32
channel DSP resources
(receivers) only for basic
chassis. When a PZ-BS10 is
installed there are 64 DSP
resources (receivers) available.
In case 0 = Common is selected
and if 14-02-10 (Caller ID
receive ability) is set to “Yes”,
DSP resources are always
allocated to analog trunks not
analog extensions. If 14-02-10
is set to “No”, DSP resources
can be used for both analog
trunks and analog extensions.
Circuit/Resource 01~08 = 1 (Extensions)
Circuit/Resource 09~32 = 2 (Trunks)
(Circuit/Resource 33~96 are not used.)
Circuit/Resource 97~160 = 0 (Common)
When PZ-BS10 is installed, 97~160 are
available.