NEC Univerge SV8100 Programming Manual - page 30
Issue 11.0
UNIVERGE SV8100
1 - 2
Introduction
Feature Cross Reference provides you with a table of all the features affected by the
program. You will want to keep the referenced features in mind when you change a
program. Customizing a feature may have an effect on another feature that you did
not intend.
Telephone Programming Instructions shows how to enter the program data into
system memory. For example:
1.
Enter the programming mode.
2.
15-07-01
tells you to enter the programming mode, dial 150701 from the telephone dial
pad. After you do, you will see the message “15-07-01 TEL” on the first line of
the telephone display. This indicates the program number (15-07), item number
(01), and that the options are being set for the extension. The second row of the
display “KY01 =
01” indicates that Key 01 is being programmed with the entry
of
01. The third row allows you to move the cursor to the left or right,
depending on which arrow is pressed. To learn how to enter the programming
mode, refer to
Section 3 How to Enter Programming Mode
below.
S
ECTION
3
H
OW
TO
E
NTER
P
ROGRAMMING
M
ODE
To enter programming mode:
1.
Go to any working display telephone.
In a newly installed system, use extension (port 1).
2.
Do not lift the handset.
3.
Press Speaker.
4.
#
#
.
5.
Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the
passwords, use
90-02 : Programming Password Setup
15-07-01 TEL
KY01 = *01
Password