NEC Univerge SV8100 Programming Manual - page 33
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
1 - 5
VOL
Scroll backward through a list of entry numbers (e.g., from extension
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling forward.
VOL
Scroll forward through a list of entry numbers (e.g., from extension
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling backward.
Table 1-2 UX5000 Terminal Keys for Entering Data
UX5000 Terminal Keys for Entering Data
Use this key...
When you want to . . .
0~9 and
Enter data into a program.
HOLD
Complete the programming step you just made (like pressing Enter
on a PC keyboard). When a program entry displays, press HOLD to
bypass the entry without changing it.
CONF
Delete the entry to the left (like pressing Backspace on a PC
keyboard).
MIC
Exit one step at a time from the program window currently being
viewed.
For example, if you’re programming item 5 in 15-03, pressing MIC will
allow you to enter a new option in program 15-03. Pressing MIC
again will allow you to select a new program in the 15- series.
Pressing MIC a third time will allow you to enter a new program
beginning with ‘1’. Pressing MIC one last time will bring you to the
beginning program display, allowing you to enter any program
number.
FLASH
Switch extension, line, etc. being programmed by pressing FLASH.
The cursor moves up to the top row of the display. Pressing FLASH
again moves the cursor back to the middle row.
Table 1-1 SV8100 Terminal Keys for Entering Data (Continued)
SV8100 Terminal Keys for Entering Data
Use this key...
When you want to...