NEC Univerge SV8100 Programming Manual - page 745
UNIVERGE SV8100
Issue 11.0
SV8100 Programming Manual
2 - 703
05
Incoming Signal Detect Time Selection
Specify the time after the incoming signal
from another system is detected before the
acknowledge signal is sent out.
Wink Start
1~15
(130ms~1950ms)
(0 = No Setting)
Delay
1~15
(30ms~450ms)
(0 = No Setting)
Wink Start
3
(390
Delay
3
(90)
06
Loop Off-Guard Time Selection
Assign loop off-guard time to prevent noise
that could cause the system to be unable to
answer an incoming Tie line.
1~4
(0.5sec~2.0sec)
5~15
(3sec~13sec)
(0 = No Setting)
4
(2.0)
07
Length of Wink Signal Selection
Specify the time a wink pulse is sent to
another system.
0~15
(30ms~480ms)
5
(180)
08
Length of Delay Signal Selection
Specify the time a delay pulse is sent to
another system.
1~15
(300ms~4.5sec)
(0 = No Setting)
1
(300ms)
09
Incoming Interdigit Timeout Selection
Specify the time that an address signal is
missing during the incoming call detection
process before an error tone is returned to
the other system.
0 = 8
1~15
(1~15 seconds)
6
10
Wink/Delay Signal Detect Timeout
Selection
To specify a maximum time, in seconds, for
receiving an acknowledgment signal from a
distant system before sending a busy tone.
0 = 8
1~15
(1~15 seconds)
7
11
Disconnect Recognition Time Selection
Specify the minimum time before a
disconnected circuit can be accessed
again.
1~15
(0.1~1.5 seconds)
(0 = No Setting)
3
(0.3)
12
Automatic Release Signal Detection
Selection
Specify the signal detection time for release
of a Tie Line after a disconnect signal is
received from the distant CO or PBX.
1~14
(50~700ms)
15 = (No limit)
(0 = No Setting)
7
(350)
13
Pause Time Selection
1~15
(500~7500ms)
6
(3000ms)
Item
No.
Item
Input Data
Default