NEC Univerge SV8100 Programming Manual - page 676
Issue 11.0
UNIVERGE SV8100
2 - 634
Program 51 : NetLink Service
Conditions
None
Feature Cross Reference
None
04
Signal Transmit Method
0 = Immediate
This is the default setting which does
not use Nagle Algorithm. When this
is enabled data packets are
immediately sent across the network
with no buffering delay.
1 = Buffering
Nagle Algorithm enabled. This
means that small data packets will
not be transmitted immediately
across the network. The smaller data
packets will be buffered and then sent
across as larger data packets
therefore decreasing the number of
packets sent across the network.
When the number of packets sent
across the network decreases, the
amount of bandwidth also decreases.
0 = Immediate
1 = Buffering
0
(Version
8000 or
lower)
1
(Version
9000 or
higher)
Input Data (Continued)
Item
No.
Item
Input Data
Default