NEC Univerge SV8100 Programming Manual - Program 51 : Netlink Service
SV8100 Programming Manual
2 - 633
Program
51
Description
Use Program 51-01 : NetLink System Property Setting to define the
parameters of the NetLink feature.
Each system must be set with its own information.
When the NetLink System ID is changed (Item 01), the system must be
reset.
Program 51 : NetLink Service
51-01 : NetLink System Property Setting
Level:
IN
Input Data
Item
No.
Item
Input Data
Default
01
NetLink System ID
This is the ID of each NetLink system.
Setting should insure that no overlap
occurs between nodes.
0~50
(0 = No operation)
0
02
Primary Candidate Order
When the Primary system is turned
off or disconnected from network, this
value is used to select a new Primary
system. Smaller number is higher
priority.
If this value is the same number, the
System ID (PRG51-01-01) is
referred, and the system which has
the smaller number is selected as
Primary system.
1~50
30
03
Secondary System Flag
0: NetLink is dynamically established
based on Node List in PRG51-03-01.
Primary System is selected in the
order which the system wakes up.
1: The system connects with Top
Priority Primary System.
If Top Priority Primary System was
not found, the system searches
Primary System like this setting is 0.
0 = Disable
1 = Enable
0