NEC Univerge SV8100 Programming Manual - page 32
Issue 11.0
UNIVERGE SV8100
1 - 4
Introduction
S
ECTION
5
U
SING
K
EYS
TO
M
OVE
A
ROUND
IN
THE
P
ROGRAMS
Once you enter the programming mode, use the keys in the following chart to enter
data, edit data and move around in the menus.
Table 1-1 SV8100 Terminal Keys for Entering Data
SV8100 Terminal Keys for Entering Data
Use this key...
When you want to...
0~9 and
Enter data into a program.
Transfer
Complete the programming step you just made (e.g., pressing Enter
on a PC keyboard). When a program entry displays, press Transfer
to bypass the entry without changing it.
Recall
Delete the entry to the left (e.g., pressing Backspace on a PC
keyboard).
Hold
Delete or clear all characters to the right of the cursor.
Answer
Exit one step at a time from the program window currently being
viewed.
For example, if programming item 5 in 15-03, pressing Answer
allows you to enter a new option in program 15-03. Pressing Answer
again allows you to select a new program in the 15-XX series.
Pressing Answer a third time allows you to enter a new program
beginning with 1. Pressing Answer one last time brings you to the
beginning program display, allowing you to enter any program
number.
MIC
Switch between the different input data fields by pressing
MIC
. The
cursor moves up to the top row of the display. Pressing
MIC
again
moves the cursor back to the middle row.
LINE KEYS
Use pre-programmed settings to help with the program entry. These
settings vary between programs from LINE 1 = 0 (off) and LINE 2 = 1
(on) to preset values for timers where LINE 1 = 5, LINE 2 = 10, LINE
3 = 15, etc.
For programs with this option, the line key, which currently matches
the programmed setting, lights steady.
The display can also indicate Softkey, which will allow you to select
the values as well (-1 and +1 will step through these pre-programmed
settings.)
LINE KEY 1
Program a pause into a Speed Dialing bin.
LINE KEY 2
Program a recall/flash into a Speed Dialing bin.
LINE KEY 3
Program an @ into a Speed Dialing bin.